Machine (Furnace) Operator - 1st shift

The operator is responsible for operating an Annealing Furnace. Clad metals and mono metals are heat treated through the furnace, based upon Engineering established parameters, and must be run continuously to prevent the production of adverse mechanical properties, or surface finishes caused by furnace stops

Responsibilities:

• Set, monitor and regulate furnace controls to process materials as required by Route Card and/or SOP instructions
• Operate overhead cranes & fork trucks to move, load, & unload coils of material
• Follow production schedule as required
• Use material handling equipment and other rigging
• Perform peel testing of product
• Use hand tools and hand held measuring instruments
• Perform preventative maintenance
• Remove defective material from coils
• Use mechanical joiner to connect coil ends and allow coils to run without stops
• Complete production and material quality data logs as necessary
• Diagnose equipment & material problems; take corrective actions as necessary
• Learn procedures for start up/shut down the furnace
• Learn procedures for re-threading strip annealing lines
• Maintain work areas in clean and orderly fashion
• Assist in all clean ups and set ups for all furnaces

Education and Experience:

• High School or Equivalency Diploma
• Experience operating related equipment

Physical Demands:

• Heavy lifting up to 25 lbs
• Standing up to 75% of time

EMS is an Equal Opportunity Employer and prohibits harassment of any kind

Powered by JazzHR

YcI1ItTMut

Recommended Skills

• Handling And Load Carrying
• Materials Management
• Mobile Device Management
• Preventive Maintenance
• Tower Crane
• Production Schedule